
Dual Fuel Range Installation 14
Anti-Tip Bracket Installation
Raise the unit to its desired height by adjusting the front
legs and rear casters. The legs and casters allow for
2
1
/8" (54) height adjustment. Use a
3
/4" socket to adjust
the rear casters. The front legs are adjusted by rotating the
bottom hexagonal portion of the leg.
Measure from the floor to the top of the range base flange
on the back of the unit. Add
1
/8" (3) to this dimension and
mark the height on the wall at the back of the installation
opening. This will mark the bottom edge of the anti-tip
bracket. Approximately center the mark in the opening.
For double oven ranges, verify that the anti-tip bracket
does not interfere with the inner cavity supports.
Locate a stud on the wall at the back of the installation
opening, and install the anti-tip bracket at the same level
as this line.
Push the range back into the opening, and ensure that the
rear base flange fits under the anti-tip bracket. Refer to
the illustration below.
IMPORTANT NOTE: The top of the range must be level.
Use the adjustable front legs and the rear casters to level
the range.
This range can tip. Injury to persons could result. Install
the anti-tip bracket supplied with the range.
ANTI-TIP
BRACKET
BACK OF
RANGE
WALL
BASE FLANGE
HEIGHT TO BASE
FLANGE +
1
/8" (3)
Anti-tip bracket.
Position the Range
IMPORTANT NOTE: Before moving the range, protect any
finished flooring to avoid damage to the floor. Secure oven
door(s) closed.
The dual fuel range has rolling casters in the rear which
allows for easy movement of the range by lifting the front
of the unit.
IMPORTANT NOTE: Do not lift the range by the oven door
handle(s). This will damage the oven door and hinges.
Move the dual fuel range into position near the installation
opening. Remove and discard all packing materials. Do
not discard the anti-tip bracket supplied with the range.
Refer to anti-tip bracket installation instructions.
If the oven door(s) need to be removed to position the
range, refer to oven door removal instructions.
If your installation requires a riser, it must be attached to
the range before installation. Refer to installation instruc-
tions packaged with the riser.
The dual fuel range is very heavy. Use caution when
lifting and moving the unit.
Comentários a estes Manuais