Wolf PL581912 Guia de Instalação descarregar pdf (Página 9)

Pro Hood Liner Installation 9

wolfappliance.com/specs

Hood Liner Installation

osition the hood liner in the desired location. Insert #10 x

(59) screws through the mounting holes on the back

plate. Verify the screws engage two wall studs or blocking.

If additional support is required, drill supplementary holes

through the back plate and secure with screws.

Before making electrical connections, make sure the

electrical power is turned off at the service panel.

Electrical Connection

IMPORTANT NOTE: Refer to specific installation instruc-

tions provided with each blower assembly for additional

mounting and wiring instructions.

1) Remove the electrical box cover from inside the hood

liner. Insert Romex

from service panel (and Romex

from in-line or remote blower, if applicable) through the

back of the hood liner and into the electrical box.

Secure with an appropriate electrical connector. Refer

to the illustration below.

2) Use wire connectors provided to connect black to

black, white to white and green to green/bare wire. For

in-line and remote blowers, attach the cord assembly

to Romex

from the blower.

3) Place all wiring connections inside the electrical box

and reinstall electrical box cover. Verify all wires are

secure and not pinched between cover.

4) Insert cord assembly plug into hood liner receptacle.

Refer to the illustration below. Turn on power and

check operation.

ELECTRICAL BOX

(INSIDE HOOD)

Location of electrical box. Location of receptacle.

RECEPTACLE

(INSIDE HOOD)

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Wolf PL581912 Guia de Instalação Página 9