Wolf 914 Guia de Instalação descarregar pdf (Página 13)

Gas Rangetop Installation 13

wolfappliance.com/specs

Verify Rangetop Operation

IMPORTANT NOTE: P

rior to operating the rangetop, be

sure to read the entire Wolf gas rangetops use & care

guide included with the rangetop for important safety,

service and warranty information.

SURFACE BURNERS

Place the burner parts on each burner base and position

the burner grates before lighting.

Surface burners of the gas rangetop use electronic

igniters. When the control knob is pushed in and turned to

the HIGH position, the system creates a spark to light the

burner. This sparking continues until the electronic ignition

senses a flame.

To check operation of the surface burners, push in and

turn each control knob to the HIGH position. The flame

should light within four seconds.

If the burners do not light properly, turn control knobs to

the OFF position. Check that burner parts are in the

proper position. Make sure electricity is being supplied to

the rangetop and that the gas shut-off valve is in the open

position. Check operation again, waiting at least five

minutes; if the burners still do not light properly, contact a

Wolf authorized service center.

IMPORTANT NOTE: Initial lighting of the surface burners

may take slightly longer, as air in the system must be

purged before gas can be supplied to the burner.

Rangetop Removal

If removal of the sealed burner rangetop is necessary for

cleaning or service, shut off the gas supply. Unplug the

rangetop and disconnect the gas supply line. Remove the

rangetop. Reinstall in the reverse order and be sure to

check gas connections for leaks.

Refer to the Wolf gas rangetops use & care guide for

cleaning recommendations.

Unplug the rangetop and disconnect the gas supply

line before removing.

1 2 ... 8 9 10 11 12 13 14 15 16

Sem comentários

Wolf 914 Guia de Instalação Página 13