Wolf 48 Especificações descarregar pdf (Página 12)

12

OV E N DO O R R E M O V A L

If removal of the oven door(s) is necessary,

follow these steps:

1)

Remove the lower kickplate assembly to

access the lower hinge retainer mounting

screws.

2)

Open the oven door to its fully opened

position and remove both upper and lower

hinge retainer mounting screws. NOTE: The

oven gasket may have to be moved slightly

to access the bottom screws.

3)

After removing the mounting screws, move

the hinge retainer plate forward slightly.

NOTE: The hinge retainer plate will remain

on the door hinge assembly after the

mounting screws have been removed.

4)

Insert the supplied door hinge pin through

the hole in the appropriate hinge arm. Refer

to the illustration below.

5)

Carefully close the oven door to about a

60° angle from horizontal and lift the door

away from the oven. NOTE: A slight rocking

motion may be required for removal.

6)

For 48" (1219) and 60" (1524) ranges,

complete these steps for both oven doors.

W O L F D UA L F U E L R A N G E S

Place Hinge Pin on

Spring Hinge Side of Door

Place Hinge Pins on

Spring Hinge Side of Door

Spring hinge location for 30" (762)

and 36" (914) ranges.

Spring hinge locations for 48" (1219)

and 60" (1524) ranges.

Hinge

Retainer

Plate

Upper Mounting

Screw

Hinge

Pin

Kickplate

Oven door removal

Failure to insert the hinge pin in the

appropriate hinge arm will cause damage

to the range. Minor injuries may occur.

Do not lift or carry the oven door by the

door handle.

IMPORTANT NOTE:

The oven door(s) should

not be removed unless it is necessary to fit the

range through a tight doorway. Door removal

should only be done by a qualified service

technician or installer. Door removal and rein-

stallation may cause damage to the oven

porcelain interior.

If removal of the oven door(s) is necessary, a

hinge pin, supplied with the range, will need to

be inserted in the appropriate hinge arm. For

each oven door, only one hinge arm is spring

loaded, requiring use of the hinge pin for

removal of the oven door. The hinge pin will

be found taped to the inside of the oven door.

For 30" (762) and 36" (914) ranges, the hinge

pin will be inserted through the hole in the

right hinge arm (facing the unit). On 48" (1219)

and 60" (1524) ranges, the spring hinges are

located on the outer edges of the unit. On

these units, the left oven door will have the

spring hinge on the left side and the right oven

door will have the spring hinge on the right

side. Refer to the illustrations below for the

location of the spring hinge(s) for your model.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários