Wolf L series Especificações descarregar pdf (Página 37)

wolfappliance.com

WOLF WARMING DRAWERS

RANGES / RANGETOPSOVENS / WARMING DRAWERS OUTDOOR GRILLS VENTILATIONCOOKTOPS / COFFEE SYSTEMS

Planning Information

The warming drawer must be installed with a Wolf drawer

front, avail able through an authorized Wolf dealer. For local

dealer information, visit the nd a showroom section of our

website, wolfappliance.com. Specic installation instruc-

tions are included with the drawer front.

The warming drawer can be installed in a standard or ush

inset application (excludes L series drawer front).

Finish the edges of the opening. They may be visible when

the drawer is open.

For standard installations, face trim will overlap stiles and

rails. Refer to the chart below.

For ush inset installations, a minimum

/8" (3) reveal is

required on all sides. To ensure consistent reveals, each

corner of the opening must be exactly 90°.

Model WWD30O is CSA approved for outdoor installations.

INSTALLATION REQUIREMENTS

BASE SUPPORT MIN

Warming Drawer 200 lbs (90 kg)

TRIM OVERLAP

Top, Bottom and Sides

/8" (16)

ELECTRICAL

Installation must comply with all applicable electrical codes.

Locate the electrical supply ush with the back wall and

within the shaded area shown in the illustrations on the

following pages. For ease of installation, the electrical

supply for the warming drawer can be placed in an adjacent

cabinet within reach of the power cord.

IMPORTANT NOTE: When installed outdoors, a ground fault

circuit interrupter (GFCI) is required to reduce the risk of

electrical shock.

ELECTRICAL REQUIREMENTS

Electrical Supply grounded, 120 VAC, 60 Hz

Service 15 or 20 amp dedicated circuit

Receptacle 3-prong grounding-type

Power Cord 3' (.9 m)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 121 122

Sem comentários

Wolf L series Especificações Página 37