
Cooktop Low-Profile Hood Installation 14
WIRING CONNECTIONS
Electrical connection at the hood:
1) Run Romex
®
wire from the service panel to the hood’s
electrical box marked “120 V AC input”.
2) Remove the cover from the electrical box and remove
one knockout as shown in illus 18 below.
3) Secure the Romex
®
wire to the electrical box through a
conduit connector. Use wire connectors or wire nuts
approved by UL or C/UL.
4) Make electrical connections at the hood. Connect
white to white, black to black and green to ground.
5) Place all wiring connections inside the electrical box
and reinstall the cover. Make sure all wires are secure
and that no wires are pinched between the cover and
electrical box.
COMPLETE THE INSTALLATION
Remove the adhesive tape and slide the lower flue
downward, placing it gently onto the hood base. Installa-
tion is now complete. Install the grease filters.
Island Hoods—Ducted Installation
ATTACH TELESCOPIC FLUE
Attach the telescopic flue to the mounting bracket with
four screws provided. Run the air evacuation pipe through
the telescopic flue and run the Romex
®
wire through the
hole in the bracket. Adjust the height of the telescopic flue
with the four retaining screws. Refer to illus 15 below. Take
into account that the height of the hood is 3
1
/8" (79) and
that the bottom of the hood should be installed 24" (610)
to 30" (762) above the countertop.
Slide the upper flue onto the telescopic flue with the slots
of the upper flue facing upwards. Attach the flue to the
bracket with two screws as shown in illus 16. Slide the
lower flue over the upper flue, to the top and temporarily
secure it in this position using adhesive tape.
Raise the hood to the telescopic flue and connect the air
outlet duct to the hood. Attach the hood to the telescopic
flue with the four screws provided. Refer to illus 17.
Illus 17. Illus 18.
ELECTRICAL
CABLE
RETAINING
SCREW
Illus 15. Illus 16.
Comentários a estes Manuais