Wolf VC36S Guia de Instalação descarregar pdf (Página 13)

wolfappliance.com

Hood Installation—In-Line/Remote Blower

WIRING CONNECTIONS

WARNING

Before making electrical connections, make sure the

electrical power is turned off at the service panel.

Home Supply:

1 Remove the knockout above the home supply junction

box, then insert the home electrical supply (Romex) into

the electrical box. Refer to the illustration below.

2 Secure the electrical supply to the electrical box with a

UL or C/UL approved connector (not provided).

3 Connect the green or bare ground wire to the green

grounding screw. Use appropriate wire connectors (not

provided) to connect white to white and black to black.

4 Place all wiring connections inside the electrical box and

then install the cover. Verify all wires are secure and not

pinched between the cover and electrical box.

In-Line/Remote Supply:

1 Remove the knockout above the in-line/remote blower

junction box, then insert the blower electrical supply

(Romex) into the electrical box.

2 Secure the electrical supply to the electrical box with a

UL or C/UL approved connector (not provided).

3 Connect the green or bare ground wire to the green

grounding screw. Use appropriate wire connectors (not

provided) to connect white to white and black to black.

4 Place all wiring connections inside the electrical box and

then install the cover. Verify all wires are secure and not

pinched between the cover and electrical box.

5 Insert the plug from the control board housing into the

receptacle on the side of the junction box.

wolfappliance.com

INSTALLATION

IN-LINE/REMOTE

BLOWER

HOME

SUPPLY

Wiring connections

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Sem comentários

Wolf VC36S Guia de Instalação Página 13