Wolf CT36G/P Manual do Utilizador descarregar pdf (Página 3)

W OLF W ARMING D RAWER I NTEGRATED F RONT

P ANEL K IT I NSTALLATION I NSTRUCTIONS

Installation Procedures:

Step 1:

• Install 2" x 4" or 2" x 2"(51 x 102

or 51 x 51) anti-tip block against rear

cabinet wall, measuring 9-1/4"(235)

from floor of cutout to the bottom of

the block.

• Install front support framing

around cabinet opening of 10-3/8"

(263). Framing must be a minimum

of 9-1/4"(235) opening to allow for

the warmer drawer installation.

• Front support framing must be a

minimum of 3/4"(19) thick.

• Mount front support frame

securely to cabinet.

CAUTION

Anti-tip Precautions: An

anti-tip block must be

installed to prevent the

warming drawer from

tipping forward when

opened. Failure to do so

could result in personal

injury.

Step 2:

• Slide left corner of the drawer into

the opening.

• If the outlet is in an adjacent

cabinet, push power cord into the

hole leading to the outlet location.

PLEASE NOTE: Check to be certain

the power cord does not get trapped

under the drawer. Thread the cord

through the hole as you push back

the drawer into the opening. You

must follow all National and/or Local

Electric Code Regulations.

• Turn power off to wall receptacle.

• If the outlet is installed in the

opening, plug the cord into the

outlet. Coil the power cord and

secure the power cord to the side of

the warming drawer with the power

cord clip.

• Push the drawer back until the

front flange is flush with the front

support frame.

• Open the drawer fully.

• Drill pilot holes through the holes

in the overlapping frame, one on

each corner.

• Drive wood screws provided with

the Warming Drawer into the four

holes.

• Install Front Panel.

• Turn power back on to wall

receptical.

Front Panel

Door

Assembly

FRONT

PANEL

DOOR

ASSEMBLY

Integrated Front Panel Panel Kit.qxd 10/10/2003 6:03 AM Page 3

1 2 3 4

Comentários a estes Manuais

Sem comentários