Wolf Wall Oven-2 Guia de Resolução de Problemas descarregar pdf (Página 27)

SETTING CONTROLS

F

or Temperature Probe feature with breads:

1)

Preheat oven to desired oven temperature

in

Bake

or

Bake Stone modes

.

2)

Place bread on bake stone or in oven in

b

read pans.

3)

Bake 10 minutes at the desired oven

temperature.

4)

Insert probe sensor into the thickest part of

the bread.

5)

Using a dry oven mitt, lift the probe sensor

cover. Slide the probe connector into the

receptacle on the wall of the oven until it

snaps into place. Close the oven door.

6)

Touch

PROBE

. Touch number pads for the

end internal baking temperature 195˚F

(90˚C) to 210˚F (100˚C).

7)

Touch

ENTER

. The word “

Lo

” appears as

the probe temperature until it registers

100˚F (40˚C). Then it shows the degrees as

they count up to the doneness setting. The

display alternates between the probe

temperature and the oven temperature.

8)

When the probe temperature is reached,

three chimes signal doneness. Remove

probe from the oven receptacle. The chime

continues every 30 seconds until the probe

is unplugged or

until you touch

CLEAR

.

9)

To end this feature and turn the oven off,

touch oven

OFF

. Oven temperature stays

on even when probe is unplugged.

27

WOLF BUILT-IN OVEN OPERATION

TEMPERATURE PROBE FEATURE

SETTING CONTROLS

F

or Temperature Probe feature with meats:

1)

Preheat oven to desired oven temperature

in desired mode.

2)

Place meat on a rack in the roasting pan.

I

nsert the probe sensor into the thickest

part of the meat as described in Tips For

Success on page 26.

3)

When the oven signals that preheat is

completed, use a dry oven mitt to lift the

probe sensor cover. Slide the probe connec-

tor into the receptacle on the wall of the

oven until it snaps into place. Close the

oven door.

4)

Touch

PROBE

. Touch number pads for the

carving temperature of the meat, less 5

degrees. It is recommended to allow meat

to rest before carving.

5)

Touch

ENTER

. The word “

Lo

” appears as

the probe temperature until it registers

100˚F (40˚C). Then it shows the degrees as

they count up to the doneness setting. The

display alternates between the probe

temperature and the oven temperature.

6)

When the probe temperature is reached,

three chimes signal doneness. Remove

probe from the oven receptacle. The chime

continues ever

y 30 seconds until the probe

is unplugged or until you touch

CLEAR

.

7)

To end this feature and turn the oven off,

touch oven

OFF

. Oven temperatur

e stays

on even when probe is unplugged.

IMPOR

T

ANT NOTE:

If the pr

obe connector is

not fully seated into the probe r

eceptacle, then

you will hear an audio signal, the display will

flash 998˚ and

PROBE

SHORTED

will show in

display

. Refer to the T

r

oubleshooting Guide on

page 37.

Pr

obe and probe sensor cover become

very hot. Handle with a dry oven mitt.

PROBE

C

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comentários a estes Manuais

Sem comentários