Wolf DD36I Manual do Utilizador descarregar pdf (Página 4)

PLANNING

The downdraft blower system is

designed to be used to exhaust

airborne contaminate when cooking

with a variety of gas or electric

cooktops. It can be mounted in an

island, peninsula, or conventional

wall location.

This unit can be easily installed

following these basic steps:

• Cut out the countertop opening.

• Mount the unit in the cabinet.

• Connect the ductwork and

electrical.

• Install the cooktop.

IMPORTANT NOTE: The high level

of airflow of this appliance may affect

the gas flame on some types of gas

cooktops. This is normal and will

cause no harm, but can be corrected

by lowering the speed of the blower.

4

D OWNDRAFT P RE-INSTALLATION

MEASURING

• Refer to the cooktop installation

instructions for dimensions of cook-

top, countertop cut-out, and cabinet

requirements. The DD30I and DD30R

will fit in most 30" wide cabinets and

the DD36I and DD36R will fit in most

36" wide cabinets. However, it is rec-

ommended that oversized cabinets

be used for easier installation.

• Cooktop depth can vary greatly

from one to another. This may cause

the fit of these two appliances to be

rather tight.

• Pay attention to the areas of

potential interference shown in the

illustration. A countertop with a

raised lip and/or a backsplash may

not allow enough flat countertop for

a proper installation. Note that 2-3/8"

of flat countertop is required behind

cooktop and that 1-3/4" is necessary

between the back edge of the cook-

top and the inside of cabinet back.

IMPORTANT NOTE: You must allow

a minimum of 25" of flat counter top

space to accommodate any down-

draft system with an approved Wolf

cooktop.

Areas of potential interference

A

countertop

cooktop

B

downdraft

2

3

/8"

1

3

/4"

front to back

inside cabinet depth

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários