Wolf DD36I Manual do Utilizador descarregar pdf (Página 5)

5

DUCTWORK

• This downdraft blower system is

designed for use with 3-1/4" x 10"

(DD30I or DD36I) or 3-1/4" x 14”

ductwork (DD30R or DD36R) and

each can be transitioned to 8" or 10"

round. Three different discharge

directions are available with side-to-

side adjustment for accurate align-

ment of ductwork. Your Wolf down-

draft system is most efficient when

used with 10" round ductwork.

• For best performance, choose the

ducting option which allows the

shortest length of ductwork and a

minimum number of elbows and

transitions. Check location of floor

joists, wall studs, electrical wiring or

plumbing for possible interference.

• The system will operate most

efficiently when the ductwork does

not exceed 40 feet of equivalent

duct.

PLANNING USER

INTERFACE

• The remote user interface is

2.375" x 6.594". There are three

holes required to mount the user

interface. The hole for the DIN con-

nector/cable is centered (1.187" x

3.297") and is 5/8" diameter. The

holes for the two mounting screws

are 2" from the center on the DIN

connector hole (1.187" x 2.297" and

1.187" x 4.297"). The holes for the

mounting screws are 1/4" diameter.

• Mark the center of the user inter-

face on the counter top. Measure 2"

up (or left) and 2" down (or right) to

locate the mounting screw locations.

IMPORTANT NOTE: The length of

the user interface control cord is 10

feet. You must plan the installation of

the user interface to be within 10 feet

from the downdraft assembly.

D OWNDRAFT I NSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários