Wolf DD36I Manual do Utilizador descarregar pdf (Página 7)

7

WIRING

• The downdraft blower system

draws 6 AMPS and requires a 120

VAC, 60 Hz circuit.

• The unit has a 2' power cord with a

3-pronged plug. Plan to provide a

grounded outlet in a location which

will allow the unit’s power cord to

reach.

IMPORTANT NOTE: If DD30I/

DD30R is being installed in a 30"

wide cabinet or DD36I/DD36R is

being installed in a 36" wide cabinet,

the outlet cannot be located on the

back wall of the cabinet.

• Outlet may also be wall-mounted,

with access hole in cabinet.

CUT COUNTERTOP

• Lay out and cut the cooktop cut-

out far enough forward so downdraft

will fit behind it.

• Set cooktop in place and slide it as

far forward as possible. Center and

square it with edges of countertop.

• Place the plastic template against

the back flange of the cooktop and

center it. Trace around the template

to mark the downdraft opening.

• Remove cooktop from countertop.

• Cut downdraft opening. Be careful

not to chip edges of countertop.

D OWNDRAFT I NSTALLATION

MOUNT THE UNIT

• Set downdraft into opening.

Extend leveling brackets to floor of

cabinet so downdraft sits straight.

NOTE: Leveling brackets can be

removed and re-attached in other

positions. Bottom flange may have

to face inward in tight cabinet

installations.

• Secure the downdraft to the coun-

tertop as follows: Hold the downdraft

against the back of the countertop

cut-out and tighten the 2 mounting

screws (one on each end of unit) on

underside of countertop.

• Screw leveling brackets to bottom

of cabinet. Tighten screws holding

leveling bracket to unit on each side.

Downdraft mounting brackets

leveling bracket – flange facing in

leveling bracket –

flange facing out

mounting screws

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários