Wolf DF604CF Manual de Serviço descarregar pdf (Página 48)

DDuuaall FFuueell RRaannggee

Component Access & Removal

4-8

Orifice Removal (SWS 17000000)

The main and simmer orifice are threaded into the ori-

fice holder and may be extracted without removing the

orifice holder from its installation position.

To remove the orifice holder,

1. Remove burner grate and pan.

2. Use a 9/32” wrench or socket with extension, to

extract orifice from orifice holder.

(See Figure 4-12A)

Orifice Holder (SWS 17000000)

The orifice holder assembly is secured with two screws

to the unit frame. Each orifice holder assembly consists

of an orifice holder, the main and simmer orifice, hat

bracket and the mounting hardware. The orifice holder

is mounted to the hat bracket with a stand-off and

spring assembly which allows the orifice holder to flex

when the burner assembly is installed.

To remove the orifice holder,

1. Remove burner grate and pan.

2. With a 3/8” and a 7/16” open end wrenches,

remove the gas supply lines from orifice holder.

(See Figure 4-12B)

3. Extract the screws securing the orifice holder to the

hat bracket.

4. Remove springs from standoffs, then lift orifice

holder off of hat bracket.

Figure 4-12A. Orifice Location

Figure 4-12B. Orifice Holder Removal

WHEN REASSEMBLING ORIFICE TO ORIFICE

HOLDER, ONLY PIPE THREAD COMPOUND

SHOULD BE USED. DO NOT

USE TEFLON TAPE

TO SEAL GAS CONNECTIONS.

Screw

Spring

Orifice Holder

Hat Bracket

Gas

Supply Port

Main Orifice

Simmer Orifice

Gas Line

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 107 108

Comentários a estes Manuais

Sem comentários

Wolf DF604CF Manual de Serviço Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Wolf DF604CF