Wolf DF604CF Manual de Serviço descarregar pdf (Página 53)

Component Access & Removal

4-13

DDuuaall FFuueell RRaannggee

Figure 4-26. Removal of Components from Bull Nose

Selector Switch Removal

To remove the selector switch, unplug the cable wire

harness from the ECH. Then, extract the screws that

secure it to the bull nose and remove. Once the selec-

tor switch has been removed, the cable wire harness

can be removed from the selector switch. (See Figure

4-26)

Indicator Light

To remove the indicator light, unplug the electrical wires

from the indicator light to the ECH. Now, remove the

spring clip that secures the indicator light to the bull

nose. Next, the indicator light can be pull out from the

front of the bull nose. (See Figure 4-26)

ECH Removal

To remove the ECH lay the bull nose down on a flat

surface with the ECH facing up towards you. Next,

locate and extract the three screws that secure the

ECH to the bull nose. (See Figure 4-27) Now, discon-

nect all wiring from the ECH. Then, lift the ECH straight

up and out from the bull nose. (See Figure 4-28)

ECH Adjustment

The ECH should be positioned in the center of the ECH

opening. If the ECH rubs or scraps when opening or

closing it can be adjusted with four screws located on

the underside of the bull nose.

To adjust the ECH, located the four screws under the

bull nose. Then, loosen the adjustment screws. Now,

position the ECH in the center of the opening and

retighten the adjustment screws. (See Figure 4-27)

NOTE:

To remove the selector switch, indicator light and

ECH, the bull nose will need to be removed from

the unit.

Figure 4-28. ECH Removal

Figure 4-27. Removal Screws and Adjustment Screws

ECH Adjustment Screws

ECH Removal Screws

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 107 108

Sem comentários

Wolf DF604CF Manual de Serviço Página 53