Wolf FB363 Instruções de Operação descarregar pdf (Página 26)

3062449_030926

Setting parameters

The standard settings for all parameters and switching times

are xed and stored in a non-volatile memory. All changes are

permanently stored and will not be lost, even if the power fails

for several weeks. Parameters are programmed via the BM

programming module. Check the description of operation and

setting / modifying parameters in the BM installation and operating

instructions.

Setting of the eBUS address

for Wolf boilers

When operating several boilers (number of boilers >1) in conjunction

with a cascade module, set the eBUS address for each boiler in

accordance with the table below.

* Address 0 cannot be changed at the Wolf boiler control unit COB. If only one Wolf boiler

control unit COB is installed in the system, then the address remains at its factory setting

(address = 1).

Boiler BUS

address

Rotary selector

position DHW

Illuminated ring indication

Individual

boiler

0* 6 ashing green

(factory setting)

1 1 1 ashing red

2 2 2 ashing yellow

3 3 3 ashing yellow/red

4 4 4 ashing yellow/green

5 5 5 ashing green/red

Hold down the reset button; after 5 seconds, the corresponding

ashing code will be displayed (see table). Select the corresponding

address with the DHW temperature rotary selector. Then release

the reset button again.

The assignment of gas red boilers or BUS addresses (1), (2),

(3) and (4) must be made on-site. Allocate each BUS address

only once.

Note: If only one BUS subscriber (boiler or KM) is isolated from

the power supply, then stop and start all subscribers via a system

switch.

BUS address setting

Reset button

Temperature

selection

DHW

Setting the eBUS address

for Wolf boilers

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Comentários a estes Manuais

Sem comentários

Wolf FB363 Instruções de Operação Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Fornos Wolf FB363